Drillco 7300 Series Solid Carbide Regular Length Finishing Center Cutting End Mill, Uncoated (Bright) Finish, 4 Flute, 30 Degrees Helix, Square Nose End, 3/4" Cutting Length, 1/4" Cutting Diameter, 2-1/2" Length, 1/4" Shank Diameter

Drillco solid carbide end mill run at extremely impressive feed and speed rate. In some cases, it can be run at 3x the rate of HSS end mill. Using solid carbide end mill results in better surface finish on the workpiece and extended tool life over conventional HSS and Cobalt end mills. Solid carbide tool offer long tool life and faster cutting speed than other substrates, but is more brittle and must be used with rigid toolholding system. Uncoated tool feature just the base substrate without any additional treatment or coating and is suitable for a wide range of application. Round shank allow use with a wide variety of toolholding system. When run in a counterclockwise direction (right-hand cut) spiral fluted tool evacuate chips up and out of the cut to reduce clogging.

• Solid carbide tools offer long tool life and faster cutting speeds than other substrates, but are more brittle and must be used with rigid toolholding systems
• Uncoated tools feature just the base substrate without any additional treatment or coatings and are suitable for a wide range of applications
• Round shanks allow use with a wide variety of toolholding systems
• When run in a counterclockwise direction (right-hand cut) spiral fluted tools evacuate chips up and out of the cut to reduce clogging
• Solid carbide end mills run at extremely impressive feed and speed rates